Chapter 8: Using the Command Line Interface
410
Changing the Modbus Configuration
You can enable or disable the Modbus agent, configure its read-only
capability, or change its TCP port.
A Modbus command begins with
network services modbus
.
Enabling or Disabling Modbus
This command enables or disables the Modbus protocol.
config:#
network services modbus enabled <option>
Variables:
<option> is one of the options:
true
or
false
.
Option
Description
true
The Modbus agent is enabled.
false
The Modbus agent is disabled.
Enabling or Disabling the Read-Only Mode
This command enables or disables the read-only mode for the Modbus
agent.
config:#
network services modbus readonly <option>
Variables:
<option> is one of the options:
true
or
false
.
Option
Description
true
The read-only mode is enabled.
false
The read-only mode is disabled.
Summary of Contents for PX3-4000 series
