Chapter 8: Using the Command Line Interface
415
Example 1 - Time Setup Method
The following command sets the date and time settings by using the NTP
servers.
config:#
time method ntp
Example 2 - Primary NTP Server
The following command sets the primary time server to 192.168.80.66.
config:#
time ntp firstServer 192.168.80.66
Security Configuration Commands
A security configuration command begins with
security
.
Firewall Control
You can manage firewall control features through the CLI. The firewall
control lets you set up rules that permit or disallow access to the PX
device from a specific or a range of IP addresses.
An IPv4 firewall configuration command begins with
security
ipAccessControl ipv4
.
An IPv6 firewall configuration command begins with
security
ipAccessControl ipv6
.
Modifying Firewall Control Parameters
There are different commands for modifying firewall control parameters.
IPv4 commands
Enable or disable the IPv4 firewall control feature:
config:#
security ipAccessControl ipv4 enabled <option>
Determine the default IPv4 firewall control policy for inbound
traffic:
config:#
security ipAccessControl ipv4 defaultPolicyIn <policy>
Determine the default IPv4 firewall control policy for outbound
traffic:
Summary of Contents for PX3-4000 series
