Chapter 8: Using the Command Line Interface
468
<hy_value> is a numeric value that is assigned to the hysteresis for
the specified inlet sensor. See
"To De-assert" and Deassertion
Hysteresis
(on page 653).
<as_value> is a numeric value that is assigned to the assertion
timeout for the specified inlet sensor. See
"To Assert" and
Assertion Timeout
(on page 651).
Commands for Inlet Pole Sensors
A sensor configuration command for inlet poles begins with
sensor
inletpole
. This type of command is available on a three-phase PDU only.
You can configure various inlet pole sensor threshold settings at a time
by combining multiple commands. See
Multi-Command Syntax
(on
page 491).
Set the Upper Critical Threshold for an Inlet Pole:
config:#
sensor inletpole <n> <p> <sensor type> upperCritical <option>
Set the Upper Warning Threshold for an Inlet Pole:
config:#
sensor inletpole <n> <p> <sensor type> upperWarning <option>
Set the Lower Critical Threshold for an Inlet Pole:
config:#
sensor inletpole <n> <p> <sensor type> lowerCritical <option>
Set the Lower Warning Threshold for an Inlet Pole:
config:#
sensor inletpole <n> <p> <sensor type> lowerWarning <option>
Set the Inlet Pole's Deassertion Hysteresis:
config:#
sensor inletpole <n> <p> <sensor type> hysteresis <hy_value>
Set the Inlet Pole's Assertion Timeout:
Summary of Contents for PX3-4000 series
