Chapter 8: Using the Command Line Interface
497
Canceling the Power-On Process
This section applies to outlet-switching capable models only.
After issuing the command to power on ALL outlets, you can use the
following command to stop the power-on process.
#
power cancelSequence
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
power cancelSequence /y
Example - Power Cycling Specific Outlets
The following command power cycles these outlets: 2, 6, 7, 8, 10, 13, 14,
15 and 16.
#
power outlets 2,6-8,10,13-16 cycle
Summary of Contents for PX3-4000 series
