Chapter 8: Using the Command Line Interface
498
Checking the Accessibility of NTP Servers
This command verifies the accessibility of NTP servers specified
manually on your PX and then shows the result. For instructions on
specifying NTP servers via CLI, see
Setting NTP Parameters
(on page
412).
To perform this command successfully, you must:
Own the "Change Date/Time Settings" permission.
Customize NTP servers. See
Setting NTP Parameters
(on page
412).
Make the customized NTP servers override the DHCP-assigned
ones. See
Overriding DHCP-Assigned NTP Servers
(on page
413).
This command is available either in the administrator/user mode or in the
configuration mode. See
Different CLI Modes and Prompts
(on page
345).
In the administrator/user mode:
#
check ntp
In the configuration mode:
config#
check ntp
Actuator Control Operations
An actuator, which is connected to a dry contact signal channel of a DX
sensor, can control a mechanism or system. You can switch on or off
that mechanism or system through the actuator control command in the
CLI.
Perform these commands in the administrator or user mode. See
Different CLI Modes and Prompts
(on page 345).
Summary of Contents for PX3-4000 series
