Appendix F: PX3 Phase I LCD Display
563
If you connect your PX to the wireless network, a Wi-Fi icon is displayed
at the bottom-right corner.
To retrieve the IP address:
1. Press the MODE button until device settings are displayed, indicated
by a 'd' in at the top left of the display.
2. The LCD display cycles between the four octets of the IPv4 address,
indicated by "i4" at the upper right corner of the display.
For example, if the IPv4 address is 192.168.84.4, the LCD display
cycles through it as shown below:
192 --> 168 --> 84 --> 4
MAC Address
This product's MAC address is retrievable by operating the LCD display.
Below illustrates the MAC address information shown on the LCD
display.
Section
Example information
"d" means the LCD display has entered the Device
mode.
"M" indicates that the displayed information is the MAC
address.
The word "MASTER" indicates the PX is the master
device in a USB-cascading configuration. See
Cascading the PX via USB
(on page 28).
For a standalone PX, this word is NOT displayed.
Summary of Contents for PX3-4000 series
