Appendix G: PX Models with Residual Current Monitoring
578
Residual Current: Residual current value in Amps.
If your PX has more than one inlet, only the inlet which has the RCM
alarm enters the critical state.
2. If needed, you can press
to perform RCM self-test for this inlet.
For details, see steps 4 to 5 in the topic titled
Running RCM
Self-Test
(on page 581).
RCM alarm information on PX3 phase I models:
The following RCM alarm messages are displayed one by one only after
the RCM enters the Critical state.
rCA --> rCA --> Residual current value (mA)
The diagram below illustrates the RCM alarm on the character LCD
display.
Summary of Contents for PX3-4000 series
