Appendix J: Integration
630
Dominion KSX II or SX Configuration
Raritan PX2, PX3 and PX3TS series support the integration with
Raritan's Dominion KSX II or SX serial access products.
Different cables are needed when connecting to different Raritan access
products.
Use a Category 5 cable to connect from the PDU (power control)
port of the Dominion KSX II to the FEATURE port of the PX.
Use a CSCSPCS cable to connect from the PDU port of the
Dominion SX to the FEATURE port of the PX.
Note: To only access the CLI of the PX via the SX, you can treat the PX
as a serial device by connecting to the PDU's serial port instead of the
FEATURE port.
For more information on either Raritan serial access product, see either
of the following:
Dominion KSX II or SX User Guide: Available on the Raritan
website's
Support page
(
http://www.raritan.com/support/
).
Dominion KSX II or SX Online Help: Available on the
Product
Online Help page
(
http://www.raritan.com/support/online-help/
).
Dominion KSX II
After connecting a Dominion KSX II to the Raritan PDU, you can monitor
the PDU and even control its outlets if the PDU is an outlet-switching
capable model.
Overview
The KSX II allows you to control Raritan PX and RPC series rack PDU
(power strip) outlets. Once a PX or RPC series is setup and then
attached to the KSX II, the rack PDU and its outlets can be controlled
from the Powerstrip page in the KSX II interface. This page is accessed
by clicking on the Power menu at the top of the page.
The Powerstrip page will display rack PDUs attached to the KSX II for
which the user has been granted appropriate port access permissions.
Note: For information on setting up a PX, see the Raritan PX Online
Help.
From the Powerstrip page, you are able to turn the outlets on and off, as
well as cycle their power. You are also able to view the following power
strip and outlet information:
Powerstrip Device Information:
Name
Summary of Contents for PX3-4000 series
