Chapter 5: Using the PDU
57
Inlet
Most of PX3 PDUs are shipped with a locking line cord, which is ready to
be plugged into the PDU's inlet and an appropriate receptacle for
electricity reception. Such devices cannot be rewired by the user.
A locking line cord helps secure the cord connection. For details, see
Connecting a Locking Line Cord
(on page 14).
Connect each PX to an appropriately rated branch circuit. See the label
or nameplate affixed to your PX for appropriate input ratings or range of
ratings.
There is no power switch on the PX device. To power cycle the PDU,
unplug it from the branch circuit, wait 10 seconds and then plug it back
in.
Besides, a PX3 "Zero U" model supports a relocatable inlet. See
Zero U
Models' Relocatable Inlet
(on page 57).
Zero U Models' Relocatable Inlet
You can easily change the inlet's location from the side to the top or from
the top to the side on a Zero U model.
Note: A PX3 phase I model does not support a relocatable inlet at the
time of writing, but may support it later.
To change a PX3 inlet's position:
1. Power OFF the PDU.
2. Remove the screws at two sides of the inlet to uninstall the inlet
module.
3. Re-install the inlet module in a manner that the inlet is located at the
desired position.
Summary of Contents for PX3-4000 series
