Chapter 8: Using the Command Line Interface
277
Current password:
4. Type the new password and press Enter when the following prompt
appears.
Enter new password:
5. Re-type the new password for confirmation and press Enter when
the following prompt appears.
Re-type new password:
Setting Default Measurement Units
Default measurement units, including temperature, length, and pressure
units, apply to the PXE user interfaces across all users except for those
whose preferred measurement units are set differently by themselves or
the administrator. Diverse measurement unit commands can be
combined so that you can set all default measurement units at a time. To
combine all commands, see
Multi-Command Syntax
(on page 311).
Note: The measurement unit change only applies to the web interface
and command line interface.
Tip: To change the preferred measurement units displayed in the PXE
user interfaces for a specific user via CLI, see
Changing Measurement
Units
(on page 274).
Set the default temperature unit:
config:#
user defaultpreferences preferredTemperatureUnit <option1>
Variables:
<option1> is one of the options:
C
or
F
.
Option
Description
C
This option displays the temperature in Celsius.
F
This option displays the temperature in
Fahrenheit.
Set the default length unit:
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......