Chapter 3: Installation and Configuration
14
To set
Use this command
IP address
returned by
the DNS
server
network ip
dnsResolverPreference
<resolver>
<resolver> =
preferV4
or
preferV6
d. After enabling the IPv4 or IPv6 protocol in the earlier step,
configure the IPv4 or IPv6 network parameters.
To set
Use this command
IPv4
configuration
method
network ipv4
ipConfigurationMode <mode>
<mode> =
dhcp
(default) or
static
IPv6
configuration
method
network ipv6
ipConfigurationMode <mode>
<mode> =
automatic
(default) or
static
Configure the preferred host name for the IPv4 DHCP or IPv6
automatic configuration.
Note: The <version> variable in all of the following commands is
either
ipv4
or
ipv6
, depending on the type of the IP protocol you have
enabled.
To set
Use this command
Preferred host
name
(optional)
network <version>
preferredHostName <name>
<name> = preferred host name
Tip: To override the DHCP-assigned DNS servers with those you
specify manually, type this command:
network <version> overrideDNS <option>
where <option> is
enable
or
disable
. See the table below for the
commands for manually specifying DNS servers.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......