Chapter 8: Using the Command Line Interface
285
Type
Description
smokeDetection The connected detector/switch is for detection of
the smoke presence.
waterDetection
The connected detector/switch is for detection of
the water presence.
vibration
The connected detector/switch is for detection of
the vibration.
Setting the X Coordinate
This command syntax specifies the X coordinate of an environmental
sensor.
config:#
externalsensor <n> xlabel "<coordinate>"
Variables:
<n> is the ID number of the environmental sensor that you want to
configure. The ID number is available in the PXE web interface or
using the show command in the CLI. It is an integer between 1 and
32.
<coordinate> is a string comprising up to 24 ASCII printable
characters, and it must be enclosed in quotes.
Setting the Y Coordinate
This command syntax specifies the Y coordinate of an environmental
sensor.
config:#
externalsensor <n> ylabel "<coordinate>"
Variables:
<n> is the ID number of the environmental sensor that you want to
configure. The ID number is available in the PXE web interface or
using the show command in the CLI. It is an integer between 1 and
32.
<coordinate> is a string comprising up to 24 ASCII printable
characters, and it must be enclosed in quotes.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......