Chapter 8: Using the Command Line Interface
313
Switching On the Actuator(s)
This command syntax turns on one or all actuators.
#
control actuator <n> on
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
control actuator <n> on
/y
Variables:
<n> is one of the options:
all
or an actuator number.
Option
Description
all
Switches ON all actuators.
A specific
actuator's ID
number
Switches ON the specified actuator.
The ID number is available in the PXE web
interface or using the show command in the CLI.
It is an integer between 1 and 32.
If you entered the command without "/y", a message appears, prompting
you to confirm the operation. Then:
Type
y
to confirm the operation, OR
Type
n
to abort the operation
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......