Chapter 6: Using the Web Interface
128
Click the Information icon
to open the Event Context Information
dialog, which contains a list of placeholders and their definitions. See
Email and SMS Message Placeholders
(on page 144) for more
details.
9. Click
OK.
Send an SNMP Notification
This option sends an SNMP notification to one or multiple SNMP
destinations.
To configure sending an SNMP notification:
1. Choose Device Settings > Event Rules. The Event Rules Settings
dialog opens.
2. Click the Actions tab.
3. Click
New.
4. In the "Action name" field, type a new name for the action. The
default name is New Action <number>, where <number> is a
sequential number starting at 1.
5. In the Action field, click the drop-down arrow and select the desired
action: Send SNMP notification.
6. Select the type of SNMP notification. See either procedure below
according to your selection.
To send SNMP v2c notifications:
1. From the Notification Type drop-down, select SNMPv2c Trap or
SNMPv2c Inform.
2. For SNMP INFORM communications, leave the resend settings at
their default or:
a. In the Timeout (sec) field, enter the interval of time, in seconds,
after which a new inform communication is resent if the first is
not received. For example, resend a new inform communication
once every 3 seconds.
b. In the Number of Retries field, enter the number of times you
want to resend the inform communication if it fails. For example,
inform communications are resent up to 5 times when the initial
communication fails.
3. In the Host fields, enter the IP address of the device(s) you want to
access. This is the address to which notifications are sent by the
SNMP system agent.
4. In the Port fields, enter the port number used to access the
device(s).
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......