185
This SNMP section helps you set up the PXE for use with an SNMP
manager. The PXE can be configured to send traps or informs to an
SNMP manager, as well as receive GET and SET commands in order to
retrieve status and configure some basic settings.
In This Chapter
Enabling SNMP .....................................................................................185
Configuring Users for Encrypted SNMP v3 ...........................................186
Configuring SNMP Notifications ............................................................187
SNMP Gets and Sets ............................................................................188
Enabling SNMP
By default, SNMP v1/v2c is enabled on the PXE so the PXE can
communicate with an SNMP manager. If you have disabled the SNMP, it
must be enabled to communicate with an SNMP manager.
Note that read-only access is enabled and the community string is public.
To enable SNMP:
1. Choose Device Settings > Network Services > SNMP. The SNMP
Settings dialog appears.
Chapter 7
Using SNMP
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......