Chapter 8: Using the Command Line Interface
195
Help Command
The help (?) command shows a list of main CLI commands available for
the current mode. This is helpful when you are not familiar with CLI
commands.
Help command under the administrator mode:
#
?
Help command under the configuration mode:
config:#
?
Help command under the diagnostic mode:
diag:#
?
Press Enter after typing the help command, and a list of main commands
for the current mode is displayed.
Tip: You can check what parameters are available for a specific CLI
command by adding the help command to the end of the queried
command. See
Querying Available Parameters for a Command
(on
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......