Chapter 8: Using the Command Line Interface
274
Changing the Role(s)
This command syntax changes the role(s) of a specific user.
config:#
user modify <name> roles <roles>
Variables:
<name> is the name of the user whose settings you want to change.
<roles> is a role or a list of comma-separated roles assigned to the
specified user profile.
Changing Measurement Units
You can change the measurement units displayed for temperatures,
length, and pressure for a specific user profile. Different measurement
unit commands can be combined so that you can set all measurement
units at a time. To combine all commands, see
Multi-Command Syntax
(on page 311).
Note: The measurement unit change only applies to the web interface
and command line interface.
Tip: To set the default measurement units applied to the PXE user
interfaces for all users via CLI, see
Setting Up User Preferences (Units
of Measure)
(see "
Setting Default Measurement Units
" on page 277).
Set the preferred temperature unit:
config:#
user modify <name> preferredTemperatureUnit <option1>
Variables:
<name> is the name of the user whose settings you want to change.
<option1> is one of the options:
C
or
F
.
Option
Description
C
This option displays the temperature in Celsius.
F
This option displays the temperature in
Fahrenheit.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......