Chapter 8: Using the Command Line Interface
279
Example 2 - Modifying a User's Roles
The following command assigns two roles to the user "May."
config:#
user modify May roles admin,tester
Results:
The user May has the union of all privileges of "admin" and "tester."
Example 3 - Default Measurement Units
The following command sets all default measurement units at a time.
config:#
user defaultpreferences preferredTemperatureUnit F preferredLengthUnit feet
preferredPressureUnit psi
Results:
The default temperature unit is set to Fahrenheit.
The default length unit is set to feet.
The default pressure unit is set to psi.
Role Configuration Commands
A role configuration command begins with
role
.
Creating a Role
This command syntax creates a new role, with a list of
semicolon-separated privileges assigned to the role.
config:#
role create <name> <privilege1>;<privilege2>;<privilege3>...
If a specific privilege contains any arguments, that privilege should be
followed by a colon and the argument(s).
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......