Chapter 8: Using the Command Line Interface
284
Environmental Sensor Configuration Commands
An environmental sensor configuration command begins with
externalsensor
. You can configure the name and location parameters of
an individual environmental sensor.
Changing the Sensor Name
This command syntax names an environmental sensor.
config:#
externalsensor <n> name "<name>"
Variables:
<n> is the ID number of the environmental sensor that you want to
configure. The ID number is available in the PXE web interface or
using the show command in the CLI. It is an integer between 1 and
32.
<name> is a string comprising up to 32 ASCII printable characters.
The <name> variable must be enclosed in quotes when it contains
spaces.
Specifying the Sensor Type
Raritan's contact closure sensor (DPX-CC2-TR) supports the connection
of diverse third-party or Raritan's detectors/switches. You must specify
the type of connected detector/switch for proper operation. Use this
command syntax when you need to specify the sensor type.
config:#
externalsensor <n> sensorSubType <sensor_type>
Variables:
<n> is the ID number of the environmental sensor that you want to
configure. The ID number is available in the PXE web interface or
using the show command in the CLI. It is an integer between 1 and
32.
<sensor_type> is one of these types:
contact
,
smokeDetection
,
waterDetection
or
vibration
.
Type
Description
contact
The connected detector/switch is for detection of
door lock or door closed/open status.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......