Chapter 8: Using the Command Line Interface
311
Example - Setting Up EnergyWise
The following command sets up two Cisco
®
EnergyWise-related features.
config:#
energywise enabled true port 10288
Results:
The EnergyWise feature implemented on the PXE is enabled.
The UDP port is set to 10288.
Setting the History Buffer Length
This command syntax sets the history buffer length, which determines
the amount of history commands that can be retained in the buffer. The
default length is 25.
config:#
history length <n>
Variables:
<n> is an integer number between 1 and 250.
Multi-Command Syntax
To shorten the configuration time, you can combine various configuration
commands in one command to perform all of them at a time. All
combined commands must belong to the same configuration type, such
as commands prefixed with
network
,
user modify
,
sensor externalsensor
and so on.
A multi-command syntax looks like this:
<configuration type> <setting 1> <value 1> <setting 2>
<value 2> <setting 3> <value 3> ...
Example 1 - Combination of IP, Subnet Mask and Gateway Parameters
The following multi-command syntax configures IPv4 address, subnet
mask and gateway for the network connectivity simultaneously.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......