Chapter 8: Using the Command Line Interface
314
Switching Off the Actuator(s)
This command syntax turns off one or all actuators.
#
control actuator <n> off
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
#
control actuator <n> off
/y
Variables:
<n> is one of the options:
all
or an actuator number.
Option
Description
all
Switches OFF all actuators.
A specific
actuator's ID
number
Switches OFF the specified actuator.
The ID number is available in the PXE web
interface or using the show command in the CLI.
It is an integer between 1 and 32.
If you entered the command without "/y", a message appears, prompting
you to confirm the operation. Then:
Type
y
to confirm the operation, OR
Type
n
to abort the operation
Example - Turning On a Specific Actuator
The following command turns on the actuator whose ID number is 8.
#
control actuator 8 on
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......