Chapter 6: Using the Web Interface
55
Tab
Data
IPv6 addresses and so on.
Outlets
Each outlet's receptacle type, operating
voltage and rated current.
Controllers
Each outlet controller's serial number, board
ID, firmware version and hardware version.
Inlets
Each inlet's plug type, rated voltage and
current.
Overcurrent Protectors
Each overcurrent protector's type, rated
current and the outlets that it protects.
Peripheral Devices
Serial numbers, model names and
firmware-related information of connected
external devices, such as environmental
sensors.
3. Enlarge the dialog if necessary.
4. You can re-sort the list or change the columns displayed.
5. Click Close to quit the dialog.
Tip: The firmware version is also available by clicking the PDU folder in
the PX Explorer pane.
Naming the PDU
The default name for PXE is
my PX
. You may give it a unique device
name.
To change the device name:
1. Click the PDU folder in the PX Explorer pane to open the PDU page.
2. Click Setup in the Settings section. The Pdu Setup dialog appears.
3. Type a new name in the Device Name field.
4. Click
OK.
Modifying the Network Configuration
The network settings you can change via the web interface include wired,
wireless, IPv4 and/or IPv6 settings.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......
