Chapter 6: Using the Web Interface
57
Selecting the Internet Protocol
The PXE device supports two types of Internet protocols -- IPv4 and IPv6.
You can enable either or both protocols. After enabling the desired
Internet protocol(s), all but not limited to the following protocols will be
compliant with the enabled Internet protocol(s):
LDAP
NTP
SMTP
SSH
Telnet
FTP
SSL
SNMP
SysLog
To select the appropriate Internet Protocol:
1. Choose Device Settings > Network. The Network Configuration
dialog appears.
2. Click the IP Protocol tab.
3. Select one checkbox according to the Internet protocol(s) you want
to enable:
IPv4 only: Enables IPv4 only on all interfaces. This is the default.
IPv6 only: Enables IPv6 only on all interfaces.
IPv4 and IPv6: Enables both IPv4 and IPv6 on all interfaces.
4. If you selected the "IPv4 and IPv6" checkbox in the previous step,
you must determine which IP address is used when the DNS
resolver returns both IPv4 and IPv6 addresses.
IPv4 Address: Use the IPv4 addresses returned by the DNS
server.
IPv6 Address: Use the IPv6 addresses returned by the DNS
server.
5. Click
OK.
Modifying IPv4 Settings
You must enable the IPv4 protocol before you can modify the IPv4
network settings. See
Selecting the Internet Protocol
(on page 57).
To modify IPv4 settings:
1. Choose Device Settings > Network. The Network Configuration
dialog appears.
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......