Chapter 6: Using the Web Interface
66
Configuring SNMP Settings
You can enable or disable SNMP communication between an SNMP
manager and the PXE device.
Besides, you may need to configure the SNMP destination(s) if the
built-in "System SNMP Notification Rule" is enabled and the SNMP
destination has not been set yet. See
Event Rules and Actions
(on
page 121).
To configure SNMP communication:
1. Choose Device Settings > Network Services > SNMP. The SNMP
Settings dialog appears.
2. Select the "enable" checkbox in the "SNMP v1 / v2c" field to enable
communication with an SNMP manager using SNMP v1 or v2c
protocol.
Type the SNMP read-only community string in the Read
Community String field. Usually the string is "public."
Type the read/write community string in the Write Community
String field. Usually the string is "private."
3. Select the "enable" checkbox in the "SNMP v3" field to enable
communication with an SNMP manager using SNMP v3 protocol.
Tip: You can permit or disallow a user to access the PXE via the
SNMP v3 protocol. See
Configuring Users for Encrypted SNMP
v3
(on page 186).
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......