Chapter 6: Using the Web Interface
78
Internal Beeper State
The PXE does NOT have an internal beeper so the 'Internal Beeper'
section on the PDU page always shows "Off."
User Management
The PXE is shipped with one built-in user profile:
admin
, which is used
for initial login and configuration. This profile has full permissions, and
should be reserved for the system administrator. It cannot be deleted
and its permissions are not user-configurable except for the SNMP v3
permission.
All users must have a user profile, which specifies a login name and
password, and contains additional (optional) information about the user.
Every user profile must have at least a role to determine the user's
permissions. See
Setting Up Roles
(on page 83).
Tip: By default, multiple users can log in simultaneously using the same
login name.
Creating a User Profile
Creating new users adds a new login to the PXE.
To create a user profile:
1. Choose User Management > Users. The Manage Users dialog
appears.
2. Click New. The Create New User dialog appears.
3. Type the information about the user in the corresponding fields. Note
that User Name, Password and Confirm Password fields are
required.
Field
Type this...
User Name
The name the user enters to log in to the PXE.
The name can be 4 to 32 characters long.
It is case sensitive.
Spaces are NOT permitted
Full Name
The user's first and last names.
Password,
Confirm Password
The password the user enters to log in. Type it
first in the Password field and then again in the
Confirm Password field.
The password can be 4 to 64 characters
Summary of Contents for PXE
Page 16: ......
Page 339: ...Appendix A Specifications 323 RS 485 Pin signal definition al 4 5 6 D bi direction al Data 7 8...
Page 380: ...Index 364 Z Zero U Products 1...
Page 381: ......
