Rascal 600B/700B Owner’s Manual
EMC Part: 19278100 Rev. 3
◦
06/29/2009
37
and sealant-injected inner tube. Replacement tires and inner tubes with
sealant are available from Electric Mobility’s Customer Service Department
or your authorized service center.
Rear Wheel Removal
Remove the center hardware holding wheel onto axle. Pull wheel off axle,
if snug, tap on tire with a rubber mallet while pulling on wheel (spin the
wheel while tapping). Remove separate key. Retain key for later
reassembly.
Re-Assembly Notes:
Slide the wheel onto axle, align key with slot in axle.
If snug, tap on wheel lightly with a rubber mallet. Replace the hardware
and tighten securely.
Front Wheel Removal
Using the proper size wrenches on the nut and bolt, remove nut. Hold
wheel and slide the bolt out of fork, being careful not to lose any of the
wheel spacers.
Re-Assembly Notes:
Align the wheel in the front fork and slide the bolt
through the fork and the wheel. Replace wheel spacers as required.
Tighten the nut and bolt securely with the proper size wrenches. Check
that the wheel spins freely. If not, loosen the nut (in quarter turn
increments) until the wheel spins freely.
Tire Tread Wear
Measure tire tread depth. If less than 1/32", it is recommended you
replace the tire.
Seat Post Lubrication
The seat should rotate freely. Clean and lubricate the top of the seat post
and the inside of the seat base attached to the seat. Lubricate with
petroleum jelly or other similar lubricant.
Rear Caster Wheels
If the rear caster wheels are badly worn it is recommended that they be
replaced.
Front Stabilizer Wheels and Forks
If the stabilizer wheels or forks are badly worn it is required that they be
replaced to maintain stability when turning.
