Rascal 600B/700B Owner’s Manual
EMC Part: 19278100 Rev. 3
◦
06/29/2009
41
Erratic behavior when
engager operated.
Faulty engager.
Contact Electric Mobility
or your Authorized
Service Center.
Ammeter
not
registering.
Batteries are fully
charged.
Turn key switch “ON”.
Battery indicator should
read “F” (Full).
Ammeter broken or wire
disconnected.
Replace ammeter or
connect wire.
Batteries
have
bad
cells. Load test batteries, if
necessary replace.
Faulty
charger.
Contact Electric Mobility
or your Authorized
Service Center.
Brake
squeals.
Dirt
in
brake
pad.
Blow dirt out with air
pressure hose.
Brake release lever sticks. Rust and corrosion.
Spray ball detent area
with lubrication oil. Be
careful not to get oil onto
the brake pad.
Stiffness in steering.
Bearings in head tube are
worn.
Replace bearings.
Controller Troubleshooting
The controller used in the scooter includes internal diagnostics
programming used to identify and troubleshoot problems and/or faults.
When this diagnostics programming detects a problem or fault, the Status
Indicator lamp on the dash/tiller flashes consecutively up to nine times to
identify the problem. These consecutive Flash Codes correspond to a cause
and action described below:
Flash Code
Cause
Action
1 X
Battery Charge Low
Scooter can be driven. Battery
charge low. Recharge as soon as
possible.
2 X
Battery Voltage Low
Scooter will not operate. Recharge
batteries.
3 X
Battery Charge High
Scooter will not operate. Unplug
charger, turn scooter power “ON” &
“OFF”, then “ON” again.