Rascal R600 Scooter Owner’s Manual
EMC Part: 19271200 • Rev. 03 • 06/01/2003
10
Electrical power to the scooter is controlled by a 2-position keyswitch on the dash. Inserting the key
and turning it to the right turns power “On.” Turning it to the left (key upright) turns power “Off.”
IMPORTANT!
Always turn scooter “Off” and remove key if you are leaving it
the toggle switch. To deactivate the turn signals place
toggle switch in the centered position.
Note:
Turn signals are not included on tiller-equipped
600C models.
Light Switch
The Rascal includes a complete complement of
Headlight, Taillights, and Running Lights for increased
visibility and safety. The 3-position switch on the dash
controls light operation.
• When in the upper position, the Headlight and
Taillights are illuminated.
• When in the lower position, only the lower front
Running Lights and Taillights are illuminated.
• When in the center position, all lights are turned off.
The keyswitch on the dash must be in the “On” position
for the headlight to operate. Hazard and turn signal lights
will operate with the key in the “Off” position.
Note:
The Model 600C lightswitch only operates the
headlight and taillights.
Horn
Pressing either horn button on the control panel sounds
the horn. Releasing the button deactivates the horn. The
horn is useful to warn people that you are coming
towards them. You may also find it helpful to use it when
rounding blind corners or going in reverse.
Keyswitch
unattended for any period of time.
This will prevent unauthorized or
accidental use.
A set of 2 keys are supplied with each Rascal Scooter.
