Rascal R600 Scooter Owner’s Manual
EMC Part: 19271200 • Rev. 03 • 06/01/2003
16
Dashboard Clock
Your Rascal 600 Series Scooter comes with a removable,
battery-powered, quartz clock that mounts directly in the
dashboard of the scooter. This clock is shipped
separately to allow you to set it to your local time before
installing in the dashboard. Instructions are provided
below to set the correct time and install it in the dash.
Instructions to replace the clock battery are provided in
the Maintenance section of this manual (see “
Clock
Battery
” on page 28).
Setting the Clock
Locate the bag containing keys, clock, and other items
shipped separately with the scooter. Unwrap the clock
from its protective packing. If clock includes a small,
plastic collar around stem, remove collar and push stem
“in” to start clock.
Set clock to your local time by pulling stem out and
turning to adjust hour/minute hands. Push stem in to
start clock.
Installing the Clock
When you have set the clock to your correct, local time,
you can install it in the dashboard of your Rascal scooter.
Install the clock into the location adjacent to the Speed
Control. The rubber gasket around the clock face is
sufficient to secure the clock in place. Make sure the
“12” faces “up.”
Illustration 9 — Clock Installation
12
3
9
6
19271200/9
