Rasha Professional A/S 1800 Rustin Ave., Riverside CA, 92507
|
|
951-654-3585
rashaprofessional.com
|
|
info@rashaprofessional.com
8
SETUP
Power Supply
Each
K2
has an auto-ranging power supply that works with an input
voltage range of 100 to 240 VAC, 50/60 Hz. To determine the power
requirements for each
K2
refer to the label affixed to the product. You
can also refer to the Technical Specifications chart in this manual
The listed current rating indicates the maximum current draw during
normal operation. For more information, you may download Sizing Circuit
Breakers from the Rasha website: www.rashaprofessional.com
Always connect this product to a protected circuit with an appropriate
electrical ground to avoid the risk of electrocution or fire. To eliminate
unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect this product to a rheostat (variable resistor) or dimmer circuit,
even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The
K2
comes with a power input cord terminated with a Neutrik
®
powerCON
®
A connector on one end and an Edison plug on the other end
(U.S. Market). If the power input cord that came with your product has no
plug, or if you need to change the Edison plug, use the table below to wire
the new plug.
Fuse
Replacement
1. Disconnect this product from the power outlet.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the
housing.
3. Remove the blown fuse and replace with a another fuse of the same
type and rating (F 10 A, 250 V).
4. Screw the fuse holder cap back in place and reconnect power.
Make sure to disconnect the product’s power cord before replacing a
blown fuse. Always replace the blown fuse with another of the same type
and rating
Power Linking
On 20 AMP circuit, you can link up-to 5 Fixtures @ 120V and 10 fixtures
@ 240V.
DMX
Personalities
• The
K2
uses a 3 pin DMX data connection for the 10/15/21/37/39
channel DMX personalities.
• Refer to the Introduction chapter for a brief description of each DMX
personality.
• Refer to the Operation chapter to learn how to configure the
K2
to work
in these personalities.
• The DMX Values section provides you with detailed information regarding
the DMX personalities
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
