Panta-V7 Wireless Profile Master-Slave Configuration
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave mode. In
Master-Slave operation one unit will act as the controlling unit and the others will
react to the controlling unit
’
s built-in programs. Any unit can act as a Master or as a
Slave however, only one unit can be programmed to act as the
“
Master.
”
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard
XLR data cables to link your units together. Remember that the Male XLR connector
is the input and the Female XLR connector is the output. The first unit in the chain
(master) will use the female XLR connector only. The last unit in the chain will use the
male XLR connector only.
2. Connect the first
“
Slave
”
unit to the
“
Master.
”
3. Set the
“
Master
”
unit to your desired mode of operation. The
“
Slave
”
unit will now
follow the
“
Master
”
.
4. Master configuration for the built in program/static color/sound active/nanu mode
5. Salve configuration for the DMX mode, or wireless dmx mode
6. Setting for Master mode: Menu\Slnd\Nast- Master Mode
7. Setting for Salve mode: Menu\Slnd\Slau- Salve Mode
If light go back automatically to the color mode or static color or sound mode please
be noted that your light in master mode you need to change the setting to the slave
mode to control the light by dmx or save the last transmission record.
If light not stable in static mode or custom mode be noted that light is salve mode,
you have set the light first at master mode to stable in standalone built in color or
effect
Tint 5-V7 Wireless Profile Operation
DMX Control:
Operating through an DMX controller gives the user the freedom to create their own programs
tailored to their own individual needs. Follow the directions below to set your DMX Mode and
address.
1. Before connecting to DMX controller, your fixture has different DMX channel modes; please
select your desired mode by pressing the DMX Mode button, then using the
“
Up
”
or
“
Down
”
buttons to scroll through the DMX Channel Modes. Set the mode before you address the
fixture. See the bottom of this page for the DMX modes.
2. After you have selected your mode, set the wireless DMX wireless transmitter, after the
transmission successful in between the light and dmx controller(wireless transmitter) the
Green Led bulb in rear side of the light it will start to blip(means the successful in
transmission).
Note:
When setting the DMX address each time a number is pressed a LED color will glow, 3.
now you may connect the fixture via the XLR connections to any standard DMX controller.
Please see below pages for a detailed description of the DMX modes, values, and traits.
T
