Panta-V7 Wireless Profile DMX Values & Functions
5 CH Modes
Channel
Value
Description
CH1
0 No
action
1-255
RED dimmer
CH2
0 No
action
1-255
GREEN dimmer
CH3
0 No
action
1-255
BLUE dimmer
CH4
0 No
action
1-255
Amber( dimmer -Sharp
CH5
0 No
action
1-255
White (0-255 white dimmer)
9 CH Modes
Channel
Value
Description
CH1
0 No
action(blackout)
1-255
RED dimmer--Bright
CH2
0
No action (blackout)
1-255
GREEN dimmer--Bright
CH3
0
No action (blackout)
1-255
BLUE dimmer--Bright
CH4
0
No action (blackout)
1-255
Amber dimmer-Bright
CH5
0
No action (blackout)
1-255
White Dimmer-Bright
CH6
0 No
action(blackout)
128-255
RGBAW dimmer-Bright
CH7
0-127
No action (blackout)
128-255
Strobe from slow to fast
CH8
0
No action (blackout)
1-255
Auto Run from slow to fast
CH9
0
No action (blackout)
1-255
Auto Run Normal
Panta-V7 Wireless Profile Power Cord Daisy Chain
With this feature you can connect the fixtures to one another using the IEC input and output
sockets. The quantity that can be connected is 33 fixtures maximum. After 33 fixtures you will
need to use a new power outlet. They must be the same fixtures. DO NOT mix fixtures.
Panta-V7 Wireless Profile Fuse Replacement
Disconnect the unit from its power source. Remove the power cord from the unit. Once the
cord has been removed, you will find that the fuse holder is located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry out the fuse holder.
Remove the bad fuse and replace with a new one. The fuse holder also has a holder for a
spare fuse.
Panta-V7 Wireless Profile Trouble Shooting
Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are wired correctly (pin 3 is
“
hot
”
;
on some other DMX devices pin 2 may be
‘
hot
’
). Also, check that all cables are connected to
the right connectors; it does matter which way the inputs and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
2. Make sure that Sound Active mode is activated.
