11
FIGURE 12
Flame Rod
Edge of Burner
AFG30 MEDIUM PLACEMENT (FIRESHAPES)
STEP ONE: Place bottom row of FireShapes into the locator holes on the ALTERNA in the order shown below begin-
ning from left to right. The four sided Pyramid (PY4-44) will fit into the first hole on the left side at a slight angle leaning
forward and to the right (Figures 12 below, and 13A, next page). The full Fireball (FB-4) will fit into the next hole with the
tapered end facing down (Figure 12). Next, place the Cube FireShapes (CU-44) into the third locator hole with the rear
right corner resting on the edge of the burner allowing it to lean slightly forward into the locator hole (Figures 12 and
15A). Now, place a flat topped Cone FireShapes (CO-63) into the next hole resting on it’s side (Figures 12 and 15). A
Cylinder (CY-63 ) will fit into the 2nd hole from the right at a slight angle resting against the Flame Rod (Figures 14B and
15B). Last, place the (CO-55) Cone into the first locator hole on the right leaning slightly forward into locator hole (Figure
14D).
STEP TWO: Begin the second row by placing the second flat topped Cone (CO-63) directly over the top left locator hole
(Figure 13B. Next, place the 2nd Cylinder (CY-63) into the 2nd hole from the left lying on it’s side with rough end facing
rear wall (Figures 12 and 15). The Half FireBall (FB -4H) will fit into the next locator hole (also with flat, rough side facing
rear wall) (Figure 15C). Last, place the 3 sided Pyramid (PY3-44) into the remaining hole leaning slightly forward (Figure
14C).
Bottom Row
Top Row
PY4-44 FB-4
CO-63
CU-44
CY-63
FIGURE 11
●
F
PY3-44
CY-63 FB -4H
PY4-44
FB-4 CU-44
CO-63
CO-63
CY-63
PY3-44
FB -4H
CO-55
CO-55
CY-63
CO-63
PY4-44 FB-4 CU-44 CO-63
CY-63
CO-55
PY3-44
FB -4H
CY-63
CO-63
