•
Do not operate in a dirty firebox or in a previously used firebox which has not had all soot completely removed or it's
chimney flue cleaned. Previously used fireboxes must have flue and stack professionally cleaned by a chimney
sweep. Additionally, firebox walls and damper must also be thoroughly cleaned of all burn residue and soot using
a damp cloth, sponge or brush.
•
Do not operate this set with any logs other than the RASMUSSEN CHILLBUSTER Refractory Logs specifically
designed and approved for use with this Burner System.
•
Do not use with blower inserts or heat exchangers.
•
If used, glass doors must be wide open when burner is on.
•
Do not remove Rating Plate/Warning Tags. These tags serve you and any future user as an integral safety and
identification component of the CHILLBUSTER gas log heater. Removing these tags voids the warranty.
•
WARNING: Do not allow fans to blow directly into fireplace. Avoid any drafts that alter burner
flame patterns. Do not place blower inside area of firebox. Ceiling fans may create drafts that alter burner flame
patterns. Sooting and improper burning may occur. Sooting can settle on surfaces outside the fireplace.
•
During periods of heavy use, inspect frequently for evidence of sooting. If sooting is present, discontinue
use until source of sooting is determined and corrected.
•
Maintain log positioning (Page 7) at all times.
HOW TO ORDER PARTS
Parts can be ordered through the supplier from whom
you purchased your log set.
When ordering parts, always specify (From information
available on name plate attached to grate) the following:
1. Model number of the log set.
2. Serial number of the log set.
3. Type of gas (natural or propane Gas).
4. The name of the part and part number from parts list.
Save these instructions
Manufactured By: RASMUSSEN IRON WORKS, INC.
12028 E. Philadelphia Street
Whittier, California 90601
CONSUMER RECORD CARD
Fill in blanks below for your permanent record.
DATE PURCHASED
MODEL NO.
DATE INSTALLED
S E R I A L N O .
INSTALLED BY:
G A S T Y P E :
DEALER:
3
2
1
4
5
6
7
1 0
4a
8
9
1 1
1 2
1 3
1 4
1 5
1 6
1 7
1 8
1 9
2 0
2 1
2 2
2 3
2 4
2 5
2 6
3 0
3 1
3 2
3 3
3 4
4 0
4 1
4 2
2 7
5 0
5 1
1.
Center Log H-13 (small)
10.
Rear Log
20.
3/8" Valve/Reg output gas
31.
1/4" Middle Burner Supply
2.
Center Log S-25 (Large)
11.
Rear Burner
Tubing
32.
1/4" Front Burner Supply
3.
Left Top Log H-14 (18" & 24")
12.
Rear Burn. Orifice (N or LP)
21.
1/4" Pilot Supply Tubing
33.
Manual Gas Valve
4.
Left Top Log Rear H-10 (30"
13.
Rear Burner Orifice
22.
ODS Pilot (N or LP
34.
Regulator (N) or (P)
Model)
Holder
MV or Standard/)
4a. Left Top Front D7 (30" Model)
14.
Middle Burner
23.
Grate
C5-A/B-S (Accessory Switch)
5.
Right Top Log D-7 (18" and 24"
15.
Mid Burn. Orifice (N or LP)
24.
Valve Knob
40.
MV Valve (3.5; 5.0 or 10.0)
Models)
16.
Mid Burner Orifice
25.
Push Button Piezo Ignitor
41.
3 Way Switch (S Model)
6.
Right Top Log H-15 (30"
Holder
26.
Ember Material
42.
Rear Burner Control Valve
Model)
17.
Front Burner
27.
3/8" Gas Supply Connector
7.
Left Middle Log
18.
Front Burn. Orifice (N or LP)
C5-A/B-R (Remote)
8.
Right Middle Log
19.
Front Burner Orifice
C5-A/B-M (Manual)
50. Remote Valve and Receiver
9.
Front Log
Holder
30
1/4" Rear Burner Supply
51. Transmitter
11
