11
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this heater may result in property damage or personal injury.
FIGURE 14
●
4.
REAR LOG: Replace Rear Log
aligning
Guide Grooves
to each end of the
Rear Burner as done in Step 2
Installation
. (Figure 12) Position between the
Rear Bracket
and
Rear Burner (Figure 13)
.
NOTE:
Thinner, less densely packed
pieces of Ember Material will enhance the overall glowing ember effect, e.g., the
looser the pieces, the better the glowing ember effect (Figure 15)!
WARNING:
Excessive amounts of Ember Material or Ember Material which is too tightly packed, or exposed ports on Front
or Middle burner can result in decreased combustion performance and elevated levels of carbon monoxide.
STEP FOUR: HF18 LOG PLACEMENT AND PAN MEDIUM
Volcanic Ash Placement:
Volcainc Ash
should only be used on the firebox floor as floor dressing (Figure 14A above).
DO NOT
place
Volcanic Ash
(or any other material other than the Ember Material provided) on top of the burners!!!
FIGURE 12
FIGURE 13
FIGURE 15
Rear Bracket
Rear Burner
Rear Burner
Guide Groove
A)
PAN MEDIUM
5.
EMBER MAGIC:
With the
Front, Middle
and
Rear Logs
on the Grate as shown in Figure 28, bottom left), pull the
Ember Magic
apart into
loose, thin pieces
and completely cover the
Front
,
Middle
and the right side of the
Rear
Burners.
Ember Material
should be one to two pieces of ember material in depth and should uniformly cover
the Burners, Including the Pilot
. To ensure proper ignition and combustion gently loosen & lift Ember Material with
a screw driver.