15
Log locator pins for;
H14 S25 D7
FIGURE 31
STEP FOUR: HF24 TOP LOG AND RECEIVER PLACEMENT
H14
H13
D7
S25
6. TOP LOGS
Using the log locator holes and pins, Place the
Large Center Log
(S25)
onto the
Center Pin
on the
Rear Log (Figures 30 and 31)
.
Place the
Small Center Log (H13)
onto the pin on the Large
Center Log
(Figures 30 and 32)
. Place the
Left Top Log (H14)
over the
Left Pin
and the
Right Top Log (D7)
over the
Right Pin
on the
Rear Log
. (Figures 30 and) 32.
S25
H13
Log Locator
Hole
Log Locator
Pin
FIGURE 32
REMOTE RECEIVER PLACEMENT (“-SE AND “-RE” MODELS)
FIGURE 33
Black Volcanic
Ash used as
Floor dressing.
A) Remote
Receiver
for “RE” and “SE”
Models
FIGURE 30
The Remote Receiver (-RE and -SE models) can be adversely affected by heat and must be placed as
far forward and
to the side of your CHILLBUSTER™ as possible
(Figure 33A). When connecting receiver to Motordrive (“-RE” mod-
els) or Solenoid (“SE models) be sure to match red and black connectors, red to red and black to black). Our optional
Ceramic Log House
accessory (Figure 33B), offers heat protection for the Remote Receiver while being pleasing to the
eye. Also sold separately, is our “Stand Alone Crackler” (Figure 33C) which mimics the sound of a crackling fire adding
a cozy feel to your log set.
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this heater may result in property damage or personal injury.
Black Volcanic
Ash used to help
conceal flex
connector
and wiring
C)
B)