17
STEP FOUR: HF30 LOG PLACEMENT AND PAN MEDIUM
FIGURE 40
●
4.
REAR LOG: Replace Rear Log
Aligning
Guide Grooves
to each end of the
Rear Burner as done in Step 2
Installation
. (Figure 40) Position between the
Rear Bracket
and
Rear Burner (Figure 41)
.
NOTE:
Thinner, less densely packed
pieces of Ember Material will enhance the overall glowing ember effect, e.g., the
looser the pieces, the better the glowing ember effect (Figure 43)!
Volcanic Ash Placement:
Volcainc Ash
should only be used on the firebox floor as floor dressing (Figure 42A above).
DO NOT
place
Volcanic
Ash
(or any other material other than the Ember Material provided) on top of the burners!!!
Rear Burner
Rear Bracket
FIGURE 41
FIGURE 42
FIGURE 43
Rear
Burner
Guide Groove
A)
PAN MEDIUM
5.
EMBER MAGIC:
With the
Front, Middle
and
Rear Logs
on the Grate as shown in Figure 28, bottom left), pull the
Ember Magic
apart into
loose, thin pieces
and completely cover the
Front
,
Middle
and the right side of the
Rear
Burners.
Ember Material
should be one to two pieces of ember material in depth and should uniformly cover
the Burners, Including the Pilot
. To ensure proper ignition and combustion gently loosen & lift Ember Material with
a screw driver.
WARNING:
Excessive amounts of Ember Material or Ember Material which is too tightly packed, or exposed ports on the
Front or Middle burner can result in decreased combustion performance and elevated levels of carbon monoxide.
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this heater may result in property damage or personal injury.