11
CY-63
PY4-44
PY4-44
FB-4
CO-63
CU-44
CY-63
CY-63
CU-44
FB-4
CO-63
PY4-44
PY4-44
FB-4
CO-63
CU-44
CY-63
FIRESHAPES PLACEMENT FOR DF-AFG24
Place FireShapes into their respective locator holes on the ALTERNA in the order shown below beginning from left to
right. The four sided Pyramid
(PY4-44)
will fit into the first hole on the left side at a slight angle leaning forward and to the
right (Figures 11 and 12). The Fireball
(FB-4)
will fit into the next hole with the tapered end facing down (Figure 11). Next,
place the Cube
(CU-44)
into the third locator hole with the rear right corner resting on the edge of the burner allowing it to
lean slightly forward into the locator hole (Figure 12). Now, place the flat topped Cone
(CO-63)
into the next hole resting
on it’s side. The Cylinder
(CY-63 )
will fit into the 2nd hole from the right at a slight angle resting against the Flame Rod
(Figures 11 and 12). Duplicate placement for opposite side.
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this heater may result in property damage or personal injury.
FIGURE 11
(Face)
FIGURE 12
(Top View)
FIGURE 13
(Right Side)
Flame Rods
