4
LOG LOCATION:
1.
Place the FRONT LOG
(the largest log) and REAR
LOG (next largest log) on grate
as shown.
2. Place TOP LOGS and
P I N E C O N E (if provided) as
shown.
NOTE: To
reduce
soot
formation on logs, place T O P
LOGs on log stack as shown to
minimize direct contact with
burner flames.
REAR LOG
PINE CONE
FRONT LOG
TOP
LOGS
TOP
LOGS
LIGHTING INSTRUCTIONS:
IMPORTANT! CHIMNEY DAMPER MUST BE WIDE OPEN
MATCH PLACEMENT POINT
(MATCH LIT MODELS ONLY)
FRONT BURNER
MIDDLE BURNER
REAR BURNER
FIGURE 3
PRIMARY GAS SUPPLY VALVE KNOB
(MATCH LIT, MANUAL PILOT CONTROL MODELS) OR
CONTROL SELECTOR SWITCH
(SWITCH PILOT CONTROL MODELS)
REAR BURNER
CONTROL VALVE
(ALL MODELS)
TR-18; 24; 30-(J) (MATCH LIT) (NATURAL GAS ONLY):
This appliance must be lighted by hand each time it is used. When lighting the appliance, follow these instructions
exactly. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or
explosion.
1. Place lighted match on right side of FRONT BURNER TRAY near inlet end of burner (FIGURE 3).
DO NOT
HOLD MATCH IN HAND!
2. Slowly open PRIMARY GAS SUPPLY VALVE and wait for burner to light. (FIGURE 3)
3. Adjust PRIMARY GAS SUPPLY VALVE to obtain desired flame height. Ensure adequate gas supply is
available to operate FRONT BURNER TRAY and MIDDLE BURNER TRAY.
TR-18; 24; 30-M-(MANUAL PILOT CONTROL)
PILOT LIGHTING AND OPERATION:
1.
Slightly push in PRIMARY GAS SUPPLY V A L V E knob and turn to
“S E A S O N / O F F ” see (FIGURES 3 & 4).
2.
Wait five minutes before lighting.
3.
Slightly push knob and turn to “P I L O T / O F F ”.
4.
Depress valve knob until air is bled and gas flows to pilot. Press PIEZZO IGNITOR
BUTTON (FIGURE 4) to light pilot. Continue to hold valve knob in until Pilot remains
lit when knob is released.
5.
Slowly turn PRIMARY GAS SUPPLY VALVE knob to “O N ”. All three burner's
(FRONT BURNER, MIDDLE BURNER and REAR BURNER) flame height is
controlled by the position of the PRIMARY GAS SUPPLY VALVE knob.
6.
If the appliance fails to light or if pilot goes out, repeat steps 1 through 5 above .
7. For complete shutdown, slightly push PRIMARY GAS SUPPLY VALVE
(FIGURE 4) knob in and turn to “S E A S O N / O F F ”.
ON
PILOT
OFF
SEASON
OFF
FIGURE 4
PIEZZO
IGNITOR
BUTTON
PRIMARY GAS
SUPPLY VALVE
