3.2 Installation Procedures
Warning:
Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
1. Unpack the carton box and check if all accessories are ready (stated in P. 17). Study the
installation procedures diagram, which is for reference only.
2. Before installation, check every functions of switching are in well condition (such as motor,
illumination). Do not touch the fan inside the hood to prevent any injury or damage to the fan.
3. Drill 1/4”(
φ
6mm) holes in designated position of clement wall, stuff the expansion anchor bolts
(1/4 x 2”) into the drilled hole. Hang the hood and tight the screws, make sure the screw drive
into the wall firmly. Do not install in calcium silicate board or decorative wooden board.
4. For replacing hood, make sure the original screws are dismantled and replaced with new
screws to avoid rusty of screw and lead to damage.
5. After machine is equipped, always keeps machine body in horizontal status.
6. Installation of exhaust pipe:
Insert one side of exhaust pipe to the adapter fitted on the top vent of machine. Then, another
side of pipe is fitted to go through exhaust hole.
Note and Importance: All the installation has to be done by a qualified person in accordance with
instructions mentioned in this manual. If you have any queries, please contact your selling agent.
20
煙囪式抽油煙機
｜
Chimney Range Hood
