8
EN
8. USE WARNINGS
We recommend following the indications below in order to always work in safety conditions.
·
All the operations must be carried out complying strictly with the safety rules of the
country where the device is to be installed.
·
It is STRICTLY FORBIDDEN to smoke during the installation or adjustment operations of
the cutting unit.
·
The Customer undertakes to comply with and make his staff observe all the rules and
regulations in force concerning safety, prevention of accidents and health in the work
place. Therefore, the Customer assumes the responsibility to strictly follow all the rules and
regulations in force, as well as the special provisions in force in sport and public installations
the Customer declares to know after receiving all the relative necessary information.
·
The cutting unit works also without its safety protective device. This protective device
must NEVER be removed.
·
Always check the resistance of the material to be cut and the kind of blade which is being
used.
·
The Customer shall equip his own personnel with all the individual safety protections for
the execution of the works, as well as with the ones which might be prescribed by the
Manufacturer due to specific danger conditions of the plant or of the area where the
personnel must work.
·
Only one operator must use the cutting unit always standing behind the guide handle. Do
not make any adjustment while the blade is working or while the electric plug is connected.
·
Always pay attention to the electric cable position to prevent it from being cut or damaged
by the blade.
·
It is allowed to assemble cutting unit D 86PS on machines O.E.M. on condition that their
original structure is not modified. Otherwise, the intervention must be certified by Rasor
®
.
Firstly make sure that the lines are able to feed the cutting unit correcltly, in
compliance with the safety rules (for the feature required see par. 5).
We suggest installing a magnetothermic safety device before the cutting unit and
check that the ground circuit is effective. Before working on the feeding cable pull
the plug out. Check that electric connections and protections correspond to the
driving force and the plate data values (voltage and current),
required by the different electric circuits. Possible faulty ground
connections make the working conditions unsafe. Possible
damages are not charged to Rasor
®
. By referring to the EC 11-
27/1 standard all the works carried out by means of electric
current must be performed by a staff, who has been provided
with all t h e dev ices re qu ired by th e above -m en ti on ed
standard. For the works carried out under voltage, it is
necessary that the employer certifies the suitability, against
formative processes. As the cutting unit D 86PS is supplied
without plug, the user must use a plug homologated in the
country in which the cutting unit is used. In the European
Countries a Shuko plug is required (see picture 3). Never change
the lenght of the cable supplied. The cutting unit D 86PS is a
class II electric device; therefore, it does not need earthing.
WARNING
3
9. ELECTRIC CONNECTION
