10
EN
13. LUBRICATION
Every 3-4 consecutive working days, it is necessary to
lubricate the pair of gears. To carry out this operation,
remove protective plug “A” located on the cutting unit
head and fill it with lubricating grease Rasor.
Screw plug “A” again few turns.
Screw plug “A” some turns every 2-3 consecutive working
days (see picture 9).
The blade must never be dirty with grease or oil.
WARNING
12. BLADE SHARPENING
After many hours of a continuative use of the cutting
unit, or if it would not be able to cut anymore, it is
necessary to sharp the blade.
To carry out this operation, start the blade and press
emery grinding wheel “2” located on it for 3-4 seconds
(by pressing push button “1”, as shown in picture 7).
Repeat the operation 2-3 times.
If the sharpening operation is not effective, check the
wear of emery grinding wheel “3” (see picture 8).
If emery grinding wheel “3” is too worn or dirty, replace
it.
14. PNEUMATIC MOTOR
In case of technical problems with the pneumatic motor, the entire motor must be
sent to Rasor
®
. Never disassemble the pneumatic motor since it could jeopardize
the guarantee.
9
A
1
2
8
3
7
