EN
9
10. USE
4
3
5
6
B
A
9. RESIDUAL RISKS
The cutting blade can work even when the protective device is disassembled.
Even though the pneumatic scissors are safe, operators must pay attention to preserve their
and other people’s safety.
To use the pneumatic scissors manually, proceed as follows:
1) Lay the material to be cut on the table;
2) Connect the air hose to the quick connection “A” (not supplied) (see picture 3);
3) Adjust the pressure gauge (option) on 6 bar;
4) Put the material on the cutting foot (see picture 4);
5) Push the starting lever after moving the safety device (see picture 5);
6) Push the pneumatic scissors in the desired direction, being careful to keep the material
in front of them as stretched as possible and preventing it from curling in the front
part of the scissors.
NOTE
The thrust on the pneumatic scissors must be as uniform as possible. To carry out linear cuts
with precision (and to follow predetermined paths), we also recommend using the arrow
point on the front protection (see point “B” in figure 6).
