EN
11
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary
to replace it. In order to carry out this operation, use
butterfly key “1” and drift “3” locking the blade (shown
in picture 10).
In order to replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
the Local Law of the Country where the cutting
unit is to be used (use of personal protection
devices);
2) Remove fixed safety protection “A” (see picture
11) by unscrewing the cross screw “C” with a
screwdriver (not supplied by the manufacturer), as
shown in picture 12.
Remove the moving front safety protection “B”
(see picture 12) by unscrewing pin “D” and taking
out the two washers “E” as shown in picture
12.
3) Insert drift “3” into hole “F” (see picture 13) in
order to lock the blade (the hole in the blade
must correspond to the hole in the structure).
4) Use butterfly key “1” in order to unscrew nut
“G” and remove blade “H” (see picture 13).
5) Replace the worn blade with the new one “2”,
being careful to center the blade on the shaft, in
the correct position, and remember to assemble
it so that the operator can see the writing “Rasor”.
6) Assemble all the components again and sharpen
the blade.
14. BLADE REPLACEMENT
10
C
D
B
A
E
11
12
H
1
G
13
F
2
1
3
3
