RASOR RS1S, Use And Maintenance Instructions

6

https://www.rasor-cutters.com

USE

2  USE

2.1 

Manual mode

Proceed as follows to cut in manual mode:

–

lay out the material on a table

–

place one edge of the textile between the blades

–

start the product in manual mode by holding down keys 

and 

. A red light appears on the keypad

–

activate the laser by pressing 

 (if desired)

–

press 

 to start cutting the textile, keeping it as taut as 

possible to prevent it curling.

2.2 

Automatic mode

Proceed as follows to cut in automatic mode:

–

lay out the material on a table

–

place one edge of the textile between the blades

–

start the product in manual mode by holding down keys 

and 

. A red light appears on the keypad.

–

activate the laser by pressing 

 (if desired)

–

tap 

 quickly twice to activate automatic cutting

–

start cutting the textile, keeping it as taut as possible to 
prevent it curling

–

tap 

 quickly to stop automatic cutting.

a 

CAUTION

Make an initial test cut to check the resistance of the 
material.

2.3 

Charging the batteries

a 

CAUTION

Use only the battery charger provided to charge the 
batteries.

The battery should be recharged when the charge level drops 
to approximately 20%.

Two LEDs on the docking station display the charge status

FUL

WJ2020

For:21700 3.7-4.2V

Li-ion battery

2A Charge

CHG

1

2

1 

If lit, the battery is charged and the device can be used

2 

If lit, the battery is being charged

a 

CAUTION

Connect the docking station to the wall charger.