Rastergraf
Installing Your Peritek Graphics Board 2-5
2.4 Eclipse3PMC Graphics Board Installation
The Eclipse3PMC board can plug into any 32-bit, 66 MHz, 5V or 3.3V
signaling IEEE 1386-2001 compatible single module PMC location. Such
locations are most commonly found on VME and CompactPCI computers.
The Eclipse3PMC can be installed in PCI and CompactPCI backplanes by
using a Rastergraf PMA-P or PMA-C passive bus adapter. Rastergraf also
supplies active carriers for PCI, the PMB-P, and a CompactPCI carrier, the
PMB-C, which can hold two PMC boards. Of course, you could also just
use an Eclipse3CPCI or Eclipse3PCI.
Note:
Older VME host or carrier boards may not supply 3.3V to the PMC
connectors and the Eclipse3 PMC boards require both 3.3V and 5V. By
special order, Rastergraf can supply the graphics board with a local 3.3V
regulator installed. Please contact Rastergraf for assistance.
Installing the PMC Graphics Board
Note:
Refer to
Section 2.3.3
for the settings for JP101 and JP201.
1. Shut down the operating system and
turn off the power
.
Warning!
Never open the computer without turning off the power supply. Unless
internal AC wiring is exposed, leave the power cord plugged in, so as to
ground the computer chassis. You can easily get shocked, ruin computer
parts or both unless you turn off the power. Even with power switched off,
lethal voltages can exist in the equipment.
