Page 4
970GSM4, 970VER4
Items Needed:
• 120vac power
• Drill
• Drill bit or knockout set
• Mounting screws
• #10 spanner bit (provided)
• Conduit with water tight connector
• Wire nuts
• Screwdriver
• Active standard size SIM Card (25mm x 15mm) with GSM or CDMA carrier
Installation:
1.
Using the supplied spanner bit, remove the 4 screws holding the front cover in place and remove the cover.
2.
Using a drill bit or knockout set, drill a hole in the bottom of the enclosure large enough for the water tight
connector.
3.
Using appropriate mounting screws, screw the enclosure onto the wall.
4.
Open the Cellular Gateway by unscrewing the screw on the left side of the front cover with a Phillips screwdriver
and gently pull up on the left side.
5.
Insert standard size SIM card (25mm x 15mm) into J4 with the perforated edge first
and the gold contact side facing downward. Push until you hear it click. If SIM card
does not click into place, the wrong size SIM card is being used.
Note:
Do NOT use a nano or micro size SIM card with an adapter. The adapter
edge can catch and cause permanent damage.
6.
Wait for the LED lights to turn on. Check the SIM LED to make sure it is amber
colored. If it is flashing red, check that the SIM card has been inserted correctly
and has an active 4G data/voice plan.
7.
A signal strength test is recommended. Check the signal strength by using the built-in network signal strength
scanner. To use the scanner function, turn on SW1 dipswitch 1 to ON (check that dipswitch 4 is also ON). When
finished, turn SW1 dipswitch 1 back to “OFF”. See Figure 1 on page 7.
8.
The RUN LED should change color to flashing green when the main power connection is made. If you see any
other color, please consult Figure 2 on page 7.
9.
Place the lid back on the top of the Cellular Gateway and fasten the lid with the screw.
10.
Run 120vac in the conduit and water tight connector. Connect 120vac to the supplied transformer in the
enclosure using proper wire nuts. Red is hot, black is neutral, and green is ground.
Note:
The transformer is wrapped separately in the box.
11.
Plug power into a battery backed up power source or RATH
®
RP7700107.
12.
Turn on the electrical power.
13.
Phone is preset to dial 911. If required to call an alternate number not given to RATH
®
at time of purchase,
please follow programming instructions on page 6. If phone is calling 911, screw internal plate back into place.
Unit is ready for testing.
J4
J4
