• The Pocket Paging System and SmartCare System will connect to the available Comm Ports of the SmartAlert
Server PC
• The SmartAlert Server connects to the router over an Ethernet cable
• A POE Plus Switch will connect to one of the available LAN router ports
• The Area Control Gateway (RC6080) connects off the POE Switch for power/communication
Hardware Connection Configurations (Figure 2)
SMARTALERT PC
PAGING
HOST CONTROLLER
AREA CONTROL
GATEWEAY
ROUTER
POE PLUS SWITCH
Installing a RATH
®
SmartAlert PC
The SmartAlert PC is preloaded with all the necessary software for your system. Battery backup is required for
the SmartAlert PC.
• Plug the power cord into the back of the PC and the other end into the battery backup
• An HDMI cable will plug into the back of the PC and other end will plug into the monitor
• Plug the AC power cord from the monitor into outlet
• Plug the network cable from the network interface port on the PC into the router or network being used
• The keyboard and mouse can both be plugged into available USB ports on the PC
• Power on the system
Using a Non RATH
®
PC
If purchasing the software only, your computer must meet the following requirements:
•
Processor Type:
X64 Processor: AMD Opteron, AMD Athlon 64, Intel Xeon with Intel EM64T support, Intel
Pentium IV with EM64T support
•
Processor Speed:
X64 Processor 1.4GHz (2.0 GHz or faster is recommended)
•
Memory:
Minimum of 1GB (2GB or more is recommended)
•
Minimum
Operating System:
Windows 10 Professional
•
.NET Framework:
4.6
•
Hard Disk:
Minimum 6GB of available hard disk space
•
COM Ports:
2 physical COM ports
•
Monitor:
Super-VGA (800x600) or higher resolution
•
Internet:
Requires internet access
Installing PC Software
• Make sure the server computer is named: RATHNURSECALLSE
• Move the current version of NurseCall to the root of the C:\ drive on the new computer and name the folder
NurseCallUpdates
• Right click on the folder and share the folder with everyone, granting read rights
Page 4
COMM 1
COMM 2