Diagnostic Test: Press
Enter 2 6 Play/Pause
phone will play back (5) Beeps (1st Beep=External Power
Supply; 2nd Beep=LED; 3rd Beep=Microphone; 4th Beep=Speaker; 5th Beep=Back-Up Battery). If any item fails
during test you will hear a Blat not a Beep. If you hear a Blat, contact the Rath Microtech Technical Dept.
Connect to standard RJ11 phone jack. If splicing connection, only hook up Red and Green Wires from the phone cable.
If connecting to a SmartRescue unit, you must connect all four wires. (Check for 24vdc or 48vdc supply at the splice)
Initial Set-Up:
If the phone does not respond, make sure the green LED (D1) on the circuit board is lit. If not, check to be sure the power is
properly connected.
3.
If the phone dials only one digit and hangs-up, there is another Auto-Dialer on the line. You need to re-wire the system so
that our unit is either in parallel or ahead of it.
1.
2.
If the phone dials a couple of digits and gets a busy signal, the unit is installed on a switchboard line and needs to be
programmed to dial the appropriate access code to get an outside line. (Usually an 8 or 9)
Troubleshooting:
N56 W24720 N. Corporate Circle Sussex, WI 53089
800-451-1460 262-246-4828 (fax) www.rathmicrotech.com
06/15
Made in the USA
3 Year Warranty
RP8200950
Revision 7
Troubleshooting & Diagrams
SmartPhone VI
1.
2.
Wiring Diagrams: 12v Models
Transf-12v
To 120 vac
Black/Hot
12+ 12-
To 12 Volt Power
Supply
Enter
Record
Play/Pause
Stop
Bat
1
1
JR
1
1
JR
mra
lA y
al
e
R
hc
ti
wS
D
EL
MIC Speaker
+ -
1
1
JR
1
1
JR
White/Neutral
12v
AC/DC
Direct 12 vac/dc Powered
Note:
Note:
120 vac to 12 vac/dc Powered
Enter
Record
Play/Pause
Stop
Bat
mra
lA y
al
e
R
hc
ti
wS
DE
L
MIC Speaker
+ -
12v
AC/DC
Note:
If utilizing our
Phone Line
Detection
feature,
connect to our
“Alarm
Connection”
Note:
If utilizing our
Phone Line
Detection
feature,
connect to our
“Alarm
Connection”
To Phone Line
Requires a
Twisted, Shielded
Pair
To Phone Line
Requires a
Twisted, Shielded
Pair
To SmartRescue
Requires Two
Twisted, Shielded
Pairs
To SmartRescue
Requires Two
Twisted, Shielded
Pairs
Note: If you receive a Blat for the LED, check the LED operation to be sure if is not working, before contacting
Rath Microtech Technical Department.
I
f you require a
relay contact
connect to our
“Relay
Connection”
If you require a
relay contact
connect to our
“Relay
Connection”
If the phone is making phantom calls it is installed on a Ring Down Line, you must turn off the “Telephone Line Check”
feature (See Optional Programming Instructions).
4.
