32
OPERATION
INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for sawing and
remodeling wooden materials, plastic,
plaster, non-ferrous metals and fasteners
(e.g. nails and clamps) as well as for working
on soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working
close to edges and for flush cutting.
WARNING: Before working your tool
make sure that no power cords will
be damaged. Before mounting or replacing
application tools or accessories, pull the
power plug. This preventative safety measure
eliminates danger from accidentally starting
the power tool.
Do not touch the gear box after long working
time, because it could be hot.
1. MOUNTING ACCESSORIES
CAUTION:
For all work or when changing
application tools, always wear protective
gloves. Avoid danger of injury from the sharp
edges of the application tools. Application tools
can become very hot while working, presenting
danger of burns!
WARNING:To reduce the risk of injury,
do not let the Universal end cut blades
or any segment saw blades face back toward
the user’s hand.
-Loosen the fastening piece
Use the Allen Key to rotate the fastening piece
clockwise. (See Fig. A)
-Insert Accessories
For the accessories with tool and most other branded
accessories,
the fastening piece must be completely removed to
install accessory (See Fig. B).
NOTA:Para o acessório Universal-Fit
TM
Insira o Acessório na Interface Universal-Fit
TM
. (Ver
Fig. C)
-Tighten the fastening piece
- Use the Allen Key to rotate the fastening piece
counterclockwise until accessory is tightened securely.
(See Fig. D)
